Add 5th Axis to Screens

[christopera]

I'm nearing the completion of my trunnion table with c axis. At a minimum I need to add that into the WC Offset panel for zeroing. I'm not proficient in VB but I assume that's what I'll need to do. Is there an easy way of achieving this?

[DaveCVI]

hi,
The easy way is: go to the settings screen, click the "load screens" button and pick the MSM MachStdMill-v3_12x9_6_axis screen set.
Dave

[christopera]

Epic!

Embarrassingly (on my part, i should have done my research) easy!

Happy holidays and thanks as always!