Calypso CNC User Forums

Hello Dave In my opinion the configuration should be independent of where the MC 0,0,0 point is set but I checked your videos again and my mill is set up in the same manner as yours. It also uses a right-handed coordinate system. I have however thought of a few additional points that may be relevant...

Hello Dave No problem! I modified the macros and managed to go get it working the way I was expecting (but perhaps not the way you initially intended). I created a custom All-LatheTouchOffY macro with the following calculation which is only used when master tool mode is ON and when the selected tool...

Tool offsets: Here is what I have figured out so far. With Master Tool Mode on, and a Tool Block Offset set. I can set the offset for the master tool. The offset recorded by pressing the "touch buttons" is the distance from the Tool Block location. All good. When I go to set the next tool...