Motor tuning doesn't open

[sivtek]

Hi Dave.
I discovered that the axis did not work properly so I tried to open the Motor tuning tab in Mac3 to check the setup, but it would not open. I have checked different forums for a solution without success. Have also asked in the ss forum but have not got an answer.
I know this is not your "table" but maybe you can help or direct me to the right forum?
(I se in the Mac3 forum the same question have been asked, but I can not find a solution to the question) .
Thanks
sivtek

[DaveCVI]

I do not have a solution for this problem. I know that you said you recently reinstalled windows - when you did that, did you "upgrade" to windows 10?
I understand that there are multiple problems with windows 10 versions 1803 and later with mach3. I'm wondering if this could be another symptom of mach3 being broken with win 10.

Dave

[sivtek]

No, I am using build 1709. Wonder if is the Mach3 or the SS causing the problem? Maybe I should start by trying to reinstall Mach3.
sivtek

[sivtek]

Hi Dave, I am happy to tell you that my problem is solved. I installed the Mac3 on top of the old one and all work correct now.
After installing I got up new icons on the desktop, tried one, but did not work so I deleted them all. The old icon, still on the desktop worked fine so now I am ok and happy.
sivtek