Is "Verify Axis" the same as "set steps per unit" in Mach3?

[ChrisAttebery]

Hi Dave,

I need to access the "set steps per unit" function that's under the Settings page in Mach. Is that the same as the Verify Axis boxes in MSM?

Thanks,


Chris

[DaveCVI]

Hi, the utility that sets steps/unit is found on the MSM Hardware page, PP driver tab - button labeled "Set Steps/Unit".
Yeah, the utility is not really PP specific, but for reasons lost in the mists of time that's where the button is in MSM.
Dave

[ChrisAttebery]

Ah ha!

You are one of the most responsive vendors I have had the pleasure of dealing with. Thanks again for your timely responses.



Chris

[DaveCVI]

Dave